Installation of sensor:
Two Kinds of Sensor

1. Adhesive Type
2.  Built-in Type (Open-Hole) 
1. Adhesive Type

 

Feature

This method need not to make hole on the car, so the car outlook is unchanged . It is fast to install. Normally this sensor is installed in luggage cabin door side or near the car rear lamp.

1.1

 After selection of sensor position, ensure that there is no obstacle within the sensing angle (90º, see the diagrams). Otherwise, it causes some improper sensing warning.
                          

1.2

 The adhesive surface should be vertical. Otherwise sensing result may be affected, as below diagrams:

1.3

  Direction of the sensor

1.4

 The horizontal distance  between two sensors
                          
2.  Built-in Type (Open-Hole)

 

Feature

To Install this type of sensor, a hole must be drilled on the bumper. The installation is permanent so the sensor may be painted to match with car rear bumper color. This type of sensor is similar to the sensor of PORSCHE, BMW and HONDA. The diameter of the hole is ø22.

        

2.1

Process to install built-in type (open-hole)
                               

2.2

Adjust the sensor angle
　

If H < 0.6m place the sensor with 5~10 degree upward angel surface

If 0.6m ≦ H< 0.8m place the sensor surface horizontally

If H ≧ 0.8m place the sensor surface with 5~10 degree downward angel